We recommend reviewing this FAQ for more information on including a Schlage Z-Wave Lock into a Z-Wave network. Enrolls into Z-Wave home automation or alarm systems for remote management and control. This is done by putting the Z-Wave controller or hub into its inclusion mode and then activating the same inclusion function on the lock using the Programming Code. 287.75 319.62 from Camelot Collection The fully loaded Schlage Connect Built-in alarm with touchscreen operation and wireless ready. You will now be able to successfully pair the lock with a new Z-Wave network. The one shown in the picture is not the one used with your lock.ģ. Remember that each lock will use a different Programming Code. You can see an example of the Programming Code sticker in the following picture. Keep in mind that you may need to have the lock in close proximity to the controller or hub for the signal to go through successfully. You should receive confirmation on the Z-Wave controller or hub that a device has been cleared. The Z-Wave controller will then clear the lock from the network. The lock will transmit a signal to the controller or hub. This kit is used to fit the Touchscreen Deadbolt with Alarm to doors that are between 1M,' and 2Zv' thick. After you have entered the code, an orange light will appear next to the key. Then enter in the Programming Code found on the white sticker underneath the device's main cover. On your Schlage Z-Wave Lock, start by activating the keypad. Continue once you have successfully entered the exclusion mode for the controller or hub.Ģ. You should check the installation manual for your Z-Wave controller or hub to determine the exact process for entering exclusion mode. If you are using a wireless all-in-one security system, then there may be an Automation Menu for doing this. The Schlage BE469 is a Z-Wave deadbolt lock that features a touchscreen for easy on-site operation. Activate the exclusion mode for your Z-Wave controller or hub. You will need this code in the future when you go to enroll or exclude the device.Ĭomplete the following steps to exclude your Schlage Z-Wave Lock:ġ. We strongly recommend saving this code and writing it down. The exclusion process is completed using the Programming Code that is found on a white sticker beneath the device's main cover. By clearing the lock first, you can be sure that the lock will pair successfully later. Many brand-new locks are paired with a network for testing purposes before even leaving the factory. You can then pair the lock with a new Z-Wave network.Ĭlearing the lock is a necessary step before trying to pair the device with a Z-Wave network. The lock will send a signal to the Z-Wave hub to clear it from the network. You can exclude your Schlage Z-Wave Lock by putting your Z-Wave controller or hub into its exclusion mode and activating the enrollment function for the lock.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |